Sointu triangular shawl Novita Baby Merino

As low as €5.95

A soft, triangular scarf with tassels from Novita Baby Merino yarn.
Novita Kevät 2020 -lehti (in Finnish)
30
Expert
Customize Sointu triangular shawl Novita Baby Merino

* Required Fields

Your Customization

    €5.95

    - +

    Availability: In stock

    N012030
    Size
    one size

    Yarn demand
    Novita Baby Merino
    (326) Silver Willow 200 g
    and some (011) White and (448) Tin for the tassels

    Needles and other supplies
    Circular needles (80 cm / 32 in) Novita 3½-4 mm (UK 8-9 / US 4-6) or size needed to obtain gauge

    Designer
    Sari Nordlund

    Cast on 5 sts and work 6 rows in garter st.

    Next row: (WS) k5, pick up and knit 3 sts from the side of the rectangle = 8 sts.

    Next row: (RS) k8, pick up and knit 3 sts from the side of the rectangle = 11 sts.

    Next row: k3, place marker, k2, place marker, k1, place marker, k2, place marker, k3.

    Begin the lace pattern following the charts:

    Row 1: work garter st to first marker, slip marker, work row 1 of chart I (= 2+2 sts), slip marker, work 1 st in garter st, slip marker, work row 1 of chart II (= 2+2 sts), slip marker, work garter st to end of row. 4 sts increased, 15 sts on the needles.

    Row 2: work garter st to first marker, slip marker, work row 2 of chart II (= 4 sts), slip marker, work 1 st in garter st, slip marker, work row 2 of chart I (= 4 sts), slip marker, work garter st to end of row = 15 sts.

    Work rows 3-28 of charts I and II. 4 sts increased on all odd-numbered rows = 67 sts.

    Row 29: work garter st to first marker, slip marker, work row 29 of chart III (= 30+2 sts), slip marker, work 1 st in garter st, slip marker, work row 29 of chart IV (= 30+2 sts), slip marker, work garter st to end of row. 4 sts increased, 71 sts on the needles.

    Row 30: work garter st to first marker, slip marker, work row 30 of chart IV, slip marker, work 1 st in garter st, slip marker, work row 30 of chart III, slip marker, work garter st to end of row = 71 sts.

    Work rows 31-56 of charts III and IV. 4 sts increased on all odd-numbered rows = 123 sts.

    Repeat rows 29-56 of charts III and IV 5 more times. The 14 st patterns are repeated 3 times the first time, 5 times the second time, etc. On the last occasion the pattern is repeated 11 times on both charts. 403 sts on the needles.

    Next row: (RS) work garter st to first marker, slip marker, increase 1 st (knit the strand of yarn between the sts through the back loop), *k2, p2*, repeat *-* to next marker, increase 1 st, slip marker, work 1 st in garter st, slip marker, increase 1 st, *k2, p2*, repeat *-* to next marker, increase 1 st, slip marker, work garter st to end of row. 4 sts increased, 407 sts on the needles.

    Next row: (WS) work garter st to first marker, slip marker, work ribbing to next marker (work the increased sts in ribbing), slip marker, work 1 st in garter st, slip marker, work ribbing to next marker (work the increased sts in ribbing), slip marker, work garter st to end of row = 407 sts.

    Work ribbing, increasing as established on each RS row, until the border measures 7 cm. Loosely bind off in pattern.

    Finishing

    Wet-block to measurements.

    Securely weave in all ends. Make approx. 9 cm long three-coloured tassels for the corners.

    Cut an approx. 10 cm wide piece of thick cardboard. Wind some White around the cardboard, then some Tin over White and some Silver Willow over Tin. Using a sewing needle thread Silver Willow below all the yarns at the top edge. Securely tie the yarns together. Cut the yarns at the bottom edge and remove the cardboard. Separate the colour layers. Tightly wrap several rounds of Silver Willow around the tassel (at approx. 1 cm from the top edge). Tie the yarn and pull the ends inside the tassel. Cut the ends of the yarns so that the Tin layer is approx. 2 cm shorter than White and Silver Willow approx. 2 cm shorter than Tin.

    Finished dimensions
    Height at midpoint approx. 70 cm / 28 in; width at top edge 155 cm / 61 in

    Stitch patterns & gauge
    Stitch pattern
    - Garter stitch: knit all rows.
    - Lace pattern: follow the chart and instructions.
    - Ribbing: *k2, p2*, repeat *-* to end of row. On the wrong side rows

    Cast on 5 sts and work 6 rows in garter st.

    Next row: (WS) k5, pick up and knit 3 sts from the side of the rectangle = 8 sts.

    Next row: (RS) k8, pick up and knit 3 sts from the side of the rectangle = 11 sts.

    Next row: k3, place marker, k2, place marker, k1, place marker, k2, place marker, k3.

    Begin the lace pattern following the charts:

    Row 1: work garter st to first marker, slip marker, work row 1 of chart I (= 2+2 sts), slip marker, work 1 st in garter st, slip marker, work row 1 of chart II (= 2+2 sts), slip marker, work garter st to end of row. 4 sts increased, 15 sts on the needles.

    Row 2: work garter st to first marker, slip marker, work row 2 of chart II (= 4 sts), slip marker, work 1 st in garter st, slip marker, work row 2 of chart I (= 4 sts), slip marker, work garter st to end of row = 15 sts.

    Work rows 3-28 of charts I and II. 4 sts increased on all odd-numbered rows = 67 sts.

    Row 29: work garter st to first marker, slip marker, work row 29 of chart III (= 30+2 sts), slip marker, work 1 st in garter st, slip marker, work row 29 of chart IV (= 30+2 sts), slip marker, work garter st to end of row. 4 sts increased, 71 sts on the needles.

    Row 30: work garter st to first marker, slip marker, work row 30 of chart IV, slip marker, work 1 st in garter st, slip marker, work row 30 of chart III, slip marker, work garter st to end of row = 71 sts.

    Work rows 31-56 of charts III and IV. 4 sts increased on all odd-numbered rows = 123 sts.

    Repeat rows 29-56 of charts III and IV 5 more times. The 14 st patterns are repeated 3 times the first time, 5 times the second time, etc. On the last occasion the pattern is repeated 11 times on both charts. 403 sts on the needles.

    Next row: (RS) work garter st to first marker, slip marker, increase 1 st (knit the strand of yarn between the sts through the back loop), *k2, p2*, repeat *-* to next marker, increase 1 st, slip marker, work 1 st in garter st, slip marker, increase 1 st, *k2, p2*, repeat *-* to next marker, increase 1 st, slip marker, work garter st to end of row. 4 sts increased, 407 sts on the needles.

    Next row: (WS) work garter st to first marker, slip marker, work ribbing to next marker (work the increased sts in ribbing), slip marker, work 1 st in garter st, slip marker, work ribbing to next marker (work the increased sts in ribbing), slip marker, work garter st to end of row = 407 sts.

    Work ribbing, increasing as established on each RS row, until the border measures 7 cm. Loosely bind off in pattern.

    Finishing

    Wet-block to measurements.

    Securely weave in all ends. Make approx. 9 cm long three-coloured tassels for the corners.

    Cut an approx. 10 cm wide piece of thick cardboard. Wind some White around the cardboard, then some Tin over White and some Silver Willow over Tin. Using a sewing needle thread Silver Willow below all the yarns at the top edge. Securely tie the yarns together. Cut the yarns at the bottom edge and remove the cardboard. Separate the colour layers. Tightly wrap several rounds of Silver Willow around the tassel (at approx. 1 cm from the top edge). Tie the yarn and pull the ends inside the tassel. Cut the ends of the yarns so that the Tin layer is approx. 2 cm shorter than White and Silver Willow approx. 2 cm shorter than Tin.


    Beginner

    Have you just learned to knit, maybe still trying to figure out the very basics like knit and purl stitches? Or are you picking up knitting again for the first time since elementary school? Start here.

    Technique

    Beginner-level patterns include only basic knitting techniques: knitting and purling. You’ll also need to cast on and cast off stitches. The projects can be worked flat or in the round. Easy, regular decreases are used. Most patterns are worked in stockinette or garter stitch. Other simple stitch patterns may occur, and they are always detailed in the written pattern. Stripes of different colours may be used, but no more advanced colourwork.

    Patterns

    All patterns are written and do not include charts. Abbreviations are not used. Getting gauge is not crucial to the finished piece. Patterns include mostly accessories such as scarved and beanies. Pillowcases and other home decoration pieces.

    Adventurous beginner

    Got the basics covered? You’d like to take a swing at your first pair of socks, perhaps some easy cables or colourwork? A treasure of patterns awaits you on this level.

    Technique

    Patterns on this level may include simple colourwork, cables or lace. Colourwork patterns repeats are relatively short, cables simple and symmetrical and lace patterns easy and relatively small, covering details rather than entire pieces. The colourwork, cable and lace stitches are not worked into decreases or increases. Colourwork yarn floats are short, max. 3-4 stitches. Picking up stitches may occur. On this level, you’ll also find easy patterns using domino knitting, log cabin knitting or tunisian crochet.

    Patterns

    Patterns may include simple charts. In case special techniques are employed, they are detailed our in the instructions, either as text or e.g. through videos. The patterns may also suggest ”shortcuts”, i.e. easier ways to accomplish a technique. Most of the basic socks with heel flaps or afterthought heels are on this level, as well as mittens with no-gusset thumbs. There’s also plenty of sweaters, usually yoke sweaters or raglan sleeve sweaters.

    Intermediate

    So knitting is a regular hobby for you? Abbreviations, charts and instructions are no more than a walk in the park? Perhaps you’re looking for something to challenge yourself with, even at the odds of frogging?

    Technique

    In addition to basic techniques, some special techniques may be employed on this level, e.g. short rows. The same pattern may include both lace and cables. Magic loop knitting or entrelac, two-coloured brioche stitch, also here. In general, patterns require a more advanced ability to "read" your knitting. Lace patterns are also more advanced than on the previous level, but the lace stitches are still worked on right side only. Intarsia may be included, but in relatively simple and symmetrical patterns.

    Patterns

    Patterns on this level can feature concurrent shaping, e.g. neckline shaping at the same time as sleeve decreases or sleeve decreases into cable pattern. Sweater sleeves may require more advanced shaping. Most of our sweaters are at this level. Other patterns include e.g. magic loop patterns and toe-up socks.

    Advanced

    Turn off that telly and lash the doors, maximum concetration required! Although this skill level doesn’t bring much more in terms of technique, there’s simply more going on at the same time. Skill, concentration and perception are requisite.

    Technique

    On this level, you’ll find more advanced intarsia patterns, including intarsia in the round. Brioche patterns with decreases and/or cables are also here. Beginning of rounds may shift and multiple markers are needed. Lace or cable stitches may be worked also from wrong side. We’ve also included patterns featuring steeks here. Steeking isn’t hard as such, but requires the nerves and confidence of an experienced knitter.

    Patterns

    Patterns may include complex steps and require simultaneous reading of both charts and written instructions. Gauge may vary over different steps of the project. The patterns often feature much details and a combination of techniques. The size of the project is not what determines whether it’s advanced or not; focus is on technique, overall complexity and the risk of errors during the project.

    Gauge and Swatching

    Every pattern is based on a certain gauge, expressed as stitches or rows per 10 cm. It is important that you make a swatch to check your gauge before you start the actual project. If your gauge doesn’t match the pattern’s gauge, your finished garment won’t be the correct size either.

    Swatching Start by knitting a swatch. Use the yarn, the needles and the stitch pattern you intend to use in the project. Make the swatch a little wider than 10 cm, so that you’ll be able to measure the stitches properly. Block the swatch by pinning it to a surface, then steam it gently. Count the stitches; put a pin in a stitch, then measure 10 cm from that stitch and put another pin there. Count the stitches from pin to pin – that’s your gauge! If needed, measure both horizontal and vertical gauge (rows). If you’re measuring rib or brioche stitches, stretch out the swatch slightly before measuring.

    Adjusting gauge

    If your gauge doesn’t match the pattern gauge, you can adjust it by switching needle size. If your swatch has too few stitches per 10 cm (i.e. your knitting is too loose), switch to smaller needles. Conversely, if your swatch has too many stitches per 10 cm, your knitting is too tight and you’ll need a larger pair of needles. Always knit another swatch in order to determine proper gauge and sizing. Also note that the pattern yardage only applies to the pattern yarn, the yardage may differ if you choose another yarn.

    Write Your Own Review
    Only registered users can write reviews. Please Sign in or create an account