Finnish Yarns and Design Since 1928
As low as €6.96
Availability: In stock
Rib:
Row 1:*K2,P2, rep from* to end.
Row 2: *K2, P2, rep from * to end.
Cable pattern: See chart.
24 sts and 25 rows to 10 cm measured over cable patt using larger needles
Using smaller needles cast on 114[126:138:150:162:174] sts. Beg and ending rows as indicated, cont in patt from chart as folls:
(WS): Row 1: Work 2sts as indicated in chart (from left end), repeat 12st patt 9(10)11(12)13(14) times, work 4 sts from right end in chart. Cont in patt and repeat rows 1-2 until back meas 6cm.
Change to larger needles. Cont in patt and repeat rows 3-12. Work until back meas 46[47:48:49:51:52] cm.
Cast off 2 sts at beg of next 12[12:12:14:14:14] rows = 90[102:114:122:134:146] sts. Work until armhole meas 19[20:21:22:22:23] cm.
Cast off 34[34:36:36:38:38] sts in the middle of back for neck and work in patt to end. Leave right side sts on a holder. Work each side of neck separately. Work 2 rows. Dec 2sts at neck edge. Work until armhole meas 21[22:23:24:24:25]cm. Cast off rem 26[32:37:41:46:52] sts. Rejoin yarn to sts on holder and patt to end. Complete to match first side, reversing shapings.
Work as back. Start front neck shaping when armhole meas 12[13:14:15:15:16]cm.
Put 24[24:26:26:28:28] sts in the middle of front for neck on a holder. Work each side of neck separately. Cast off 2sts at neck edge every alt row twice. Dec 1 st at neck edge every alt row 3 times. Work until armhole meas 21[22:23:24:24:25] cm. Cast off rem 26[32:37:41:46:52] sts. Rejoin yarn to sts on holder (left end) and patt to end. Complete to match first side, reversing shapings.
Using smaller needles cast on 60[60:62:64:66:70] sts. Beg and ending rows as indicated, cont in patt from chart as folls:
Row 1: Sleeve middle stitch is marked in chart with an arrow, count from there your starting st. Cont in patt and work rows 1-2. Work until sleeve meas 6 cm. Change to larger needles. Cont in patt and repeat rows 3-12. AT THE SAME TIME inc 1 st at each end every 8[6:6:6:6:6] row 3(17)16(13)16(18) times and every 6[4:4:4:4:4] row 13(1)3(8)4(2) times = 92[96:100:106:106:110] sts. Work increased sts in cable patt. Work until sleeve meas 49[50:51:52:53:54] cm.
Cast off 2 sts at beg of next 12[12:12:14:14:14] rows. Cast off rem sts.
Flatten the pieces to the desired dimensions on an even surface, wrong side up. Wet with water spray, and allow to dry. Join both shoulder seams.
Using 40cm circular needle rejoin yarn to 24[24:26:26:28:28] sts on a holder, pick up and knit 80[80:78:82:80:80]sts evenly from neck edge =104[104:104:108:108:108] sts. Work in rib in round 9cm. Cast off sts in rib. Fold the collar in half and sew it into WS.
Set in sleeves ( red attaching mark in pattern). Join side seams and sleeve seams using back stitch or matress stitch if preferred.
Rib:
Row 1:*K2,P2, rep from* to end.
Row 2: *K2, P2, rep from * to end.
Cable pattern: See chart.
24 sts and 25 rows to 10 cm measured over cable patt using larger needles
Using smaller needles cast on 114[126:138:150:162:174] sts. Beg and ending rows as indicated, cont in patt from chart as folls:
(WS): Row 1: Work 2sts as indicated in chart (from left end), repeat 12st patt 9(10)11(12)13(14) times, work 4 sts from right end in chart. Cont in patt and repeat rows 1-2 until back meas 6cm.
Change to larger needles. Cont in patt and repeat rows 3-12. Work until back meas 46[47:48:49:51:52] cm.
Cast off 2 sts at beg of next 12[12:12:14:14:14] rows = 90[102:114:122:134:146] sts. Work until armhole meas 19[20:21:22:22:23] cm.
Cast off 34[34:36:36:38:38] sts in the middle of back for neck and work in patt to end. Leave right side sts on a holder. Work each side of neck separately. Work 2 rows. Dec 2sts at neck edge. Work until armhole meas 21[22:23:24:24:25]cm. Cast off rem 26[32:37:41:46:52] sts. Rejoin yarn to sts on holder and patt to end. Complete to match first side, reversing shapings.
Work as back. Start front neck shaping when armhole meas 12[13:14:15:15:16]cm.
Put 24[24:26:26:28:28] sts in the middle of front for neck on a holder. Work each side of neck separately. Cast off 2sts at neck edge every alt row twice. Dec 1 st at neck edge every alt row 3 times. Work until armhole meas 21[22:23:24:24:25] cm. Cast off rem 26[32:37:41:46:52] sts. Rejoin yarn to sts on holder (left end) and patt to end. Complete to match first side, reversing shapings.
Using smaller needles cast on 60[60:62:64:66:70] sts. Beg and ending rows as indicated, cont in patt from chart as folls:
Row 1: Sleeve middle stitch is marked in chart with an arrow, count from there your starting st. Cont in patt and work rows 1-2. Work until sleeve meas 6 cm. Change to larger needles. Cont in patt and repeat rows 3-12. AT THE SAME TIME inc 1 st at each end every 8[6:6:6:6:6] row 3(17)16(13)16(18) times and every 6[4:4:4:4:4] row 13(1)3(8)4(2) times = 92[96:100:106:106:110] sts. Work increased sts in cable patt. Work until sleeve meas 49[50:51:52:53:54] cm.
Cast off 2 sts at beg of next 12[12:12:14:14:14] rows. Cast off rem sts.
Flatten the pieces to the desired dimensions on an even surface, wrong side up. Wet with water spray, and allow to dry. Join both shoulder seams.
Using 40cm circular needle rejoin yarn to 24[24:26:26:28:28] sts on a holder, pick up and knit 80[80:78:82:80:80]sts evenly from neck edge =104[104:104:108:108:108] sts. Work in rib in round 9cm. Cast off sts in rib. Fold the collar in half and sew it into WS.
Set in sleeves ( red attaching mark in pattern). Join side seams and sleeve seams using back stitch or matress stitch if preferred.
Have you just learned to knit, maybe still trying to figure out the very basics like knit and purl stitches? Or are you picking up knitting again for the first time since elementary school? Start here.
Beginner-level patterns include only basic knitting techniques: knitting and purling. You’ll also need to cast on and cast off stitches. The projects can be worked flat or in the round. Easy, regular decreases are used. Most patterns are worked in stockinette or garter stitch. Other simple stitch patterns may occur, and they are always detailed in the written pattern. Stripes of different colours may be used, but no more advanced colourwork.
All patterns are written and do not include charts. Abbreviations are not used. Getting gauge is not crucial to the finished piece. Patterns include mostly accessories such as scarved and beanies. Pillowcases and other home decoration pieces.
Got the basics covered? You’d like to take a swing at your first pair of socks, perhaps some easy cables or colourwork? A treasure of patterns awaits you on this level.
Patterns on this level may include simple colourwork, cables or lace. Colourwork patterns repeats are relatively short, cables simple and symmetrical and lace patterns easy and relatively small, covering details rather than entire pieces. The colourwork, cable and lace stitches are not worked into decreases or increases. Colourwork yarn floats are short, max. 3-4 stitches. Picking up stitches may occur. On this level, you’ll also find easy patterns using domino knitting, log cabin knitting or tunisian crochet.
Patterns may include simple charts. In case special techniques are employed, they are detailed our in the instructions, either as text or e.g. through videos. The patterns may also suggest ”shortcuts”, i.e. easier ways to accomplish a technique. Most of the basic socks with heel flaps or afterthought heels are on this level, as well as mittens with no-gusset thumbs. There’s also plenty of sweaters, usually yoke sweaters or raglan sleeve sweaters.
So knitting is a regular hobby for you? Abbreviations, charts and instructions are no more than a walk in the park? Perhaps you’re looking for something to challenge yourself with, even at the odds of frogging?
In addition to basic techniques, some special techniques may be employed on this level, e.g. short rows. The same pattern may include both lace and cables. Magic loop knitting or entrelac, two-coloured brioche stitch, also here. In general, patterns require a more advanced ability to "read" your knitting. Lace patterns are also more advanced than on the previous level, but the lace stitches are still worked on right side only. Intarsia may be included, but in relatively simple and symmetrical patterns.
Patterns on this level can feature concurrent shaping, e.g. neckline shaping at the same time as sleeve decreases or sleeve decreases into cable pattern. Sweater sleeves may require more advanced shaping. Most of our sweaters are at this level. Other patterns include e.g. magic loop patterns and toe-up socks.
Turn off that telly and lash the doors, maximum concetration required! Although this skill level doesn’t bring much more in terms of technique, there’s simply more going on at the same time. Skill, concentration and perception are requisite.
On this level, you’ll find more advanced intarsia patterns, including intarsia in the round. Brioche patterns with decreases and/or cables are also here. Beginning of rounds may shift and multiple markers are needed. Lace or cable stitches may be worked also from wrong side. We’ve also included patterns featuring steeks here. Steeking isn’t hard as such, but requires the nerves and confidence of an experienced knitter.
Patterns may include complex steps and require simultaneous reading of both charts and written instructions. Gauge may vary over different steps of the project. The patterns often feature much details and a combination of techniques. The size of the project is not what determines whether it’s advanced or not; focus is on technique, overall complexity and the risk of errors during the project.
Every pattern is based on a certain gauge, expressed as stitches or rows per 10 cm. It is important that you make a swatch to check your gauge before you start the actual project. If your gauge doesn’t match the pattern’s gauge, your finished garment won’t be the correct size either.
Swatching Start by knitting a swatch. Use the yarn, the needles and the stitch pattern you intend to use in the project. Make the swatch a little wider than 10 cm, so that you’ll be able to measure the stitches properly. Block the swatch by pinning it to a surface, then steam it gently. Count the stitches; put a pin in a stitch, then measure 10 cm from that stitch and put another pin there. Count the stitches from pin to pin – that’s your gauge! If needed, measure both horizontal and vertical gauge (rows). If you’re measuring rib or brioche stitches, stretch out the swatch slightly before measuring.
If your gauge doesn’t match the pattern gauge, you can adjust it by switching needle size. If your swatch has too few stitches per 10 cm (i.e. your knitting is too loose), switch to smaller needles. Conversely, if your swatch has too many stitches per 10 cm, your knitting is too tight and you’ll need a larger pair of needles. Always knit another swatch in order to determine proper gauge and sizing. Also note that the pattern yardage only applies to the pattern yarn, the yardage may differ if you choose another yarn.