Finnish Yarns and Design Since 1928
Ab 6,62 €
16(20)24(28) M mit dem doppelten Faden anschlagen und gleichmässig auf 4 Nadeln des Nadelspiels verteilen. 1 Rd li stricken und dann 5(6)7(8) Rd glatt rechts stricken. Die Arbeit nach links wenden und 12(16)22(24) Rd glatt rechts stricken.
Daumenloch: die erste 3(4)4(5) M der 2. Nadel mit dem andersfarbigen Faden stricken. Die Maschen zurück auf die linke Nadel abheben und weiter normalerweise glatt rechts stricken.
Nach 12(16)18(20) Rd ab Daumenloch die Abnehmen für die Spitze beginnen: am Anfang der 1. und 3. Nadel ein überzogenes Abnehmen (= 1 M wie zum Rechtsstricken abheben, 1 M re, die abgehobene M über die gestrickte M ziehen) arbeiten und am Ende der 2. und 4. Nadel 2 M re zusammenstricken. In dieser Weise in jeder zweiten Rd die Abnehmen weiterarbeiten, bis 8 M übrig sind. Den Faden abschneiden, durch die restlichen M ziehen und vernähen.
Gegengleich stricken, d. h. das Daumenloch am Ende von der 3. Nadel stricken.
Den andersfarbigen Faden aus dem Daumenloch entfernen und die M auf die Nadeln nehmen. Aus den beiden Seiten des Daumenloch 2 zusätzliche Maschen auffassen = 10 (12) 12 (14) M. Diese Maschen gleichmässig auf 3 Nadeln des Nadelspiels verteilen und ca. 4 (5) 7 (8) cm glatt rechts in Runden stricken. Dann durchgehend 1 Rd 2 M re zusammenstricken. Den Faden abschneiden, durch die restlichen M ziehen und vernähen.
Mit Novita Isoveli Feldstein und Rußschwarz in das Rohr des Fäustlings das Muster laut Bild sticken. Am Anfang ca. 15 cm Faden verlassen, damit Sie die Zöpfe flechten können. Novita Joki Naturweiss für die Zöpfe stecken, ca. 8 cm flechten und den Zopf mit einem dichten Knoten in Novita Isoveli schliessen. Die Fäden flach ca. 2 cm vom Knoten abschneiden.
Availability: Auf Lager
skill level deutsch
Every pattern is based on a certain gauge, expressed as stitches or rows per 10 cm. It is important that you make a swatch to check your gauge before you start the actual project. If your gauge doesn’t match the pattern’s gauge, your finished garment won’t be the correct size either.
Swatching Start by knitting a swatch. Use the yarn, the needles and the stitch pattern you intend to use in the project. Make the swatch a little wider than 10 cm, so that you’ll be able to measure the stitches properly. Block the swatch by pinning it to a surface, then steam it gently. Count the stitches; put a pin in a stitch, then measure 10 cm from that stitch and put another pin there. Count the stitches from pin to pin – that’s your gauge! If needed, measure both horizontal and vertical gauge (rows). If you’re measuring rib or brioche stitches, stretch out the swatch slightly before measuring.
If your gauge doesn’t match the pattern gauge, you can adjust it by switching needle size. If your swatch has too few stitches per 10 cm (i.e. your knitting is too loose), switch to smaller needles. Conversely, if your swatch has too many stitches per 10 cm, your knitting is too tight and you’ll need a larger pair of needles. Always knit another swatch in order to determine proper gauge and sizing. Also note that the pattern yardage only applies to the pattern yarn, the yardage may differ if you choose another yarn.